Framing repair
Damaged structure is repaired for a straight, solid roof.
Metal Roofing
Metal Roof Replacement Succasunna, NJ
A roofer in Succasunna can replace a metal roof that has rusted through, lost its finish or been riddled with worn screw holes, down to the purlins or deck, so the new roof is set up for decades. Dial (862) 453-8001 to talk with a local roofer about replacing the roof.
Replacement comes up once rust or wear has spread past what patches and new fasteners can fix. Rust that has eaten through panels in many places, paint that has chalked and worn down to bare metal and screw holes that have wallowed out across the whole roof all point toward new panels. Older roofs made from thin, lightly coated steel tend to reach that point first.
Replacement can mean a full tear-off, a re-cover or panel by panel work. Tearing off lets the roofer see rotten purlins, soft decking and rusted fasteners before anything new is installed. A re-cover, or retrofit, installs new metal over the old panels on new sub-framing, which is common on shops and large buildings.
Plenty of homeowners replace an old shingle roof with metal rather than more shingles. The shingles can come off or, if local code permits and the deck is sound, the metal can go over them. Have the age, roof type and leak history ready when you call.
If the problem goes deeper than it first looked, a Succasunna roofer may also recommend metal roof installation or metal roof repair.
Need metal roof replacement in Succasunna? Call (862) 453-8001 and describe the problem to a roofer who works in Succasunna.
Call nowThe process
What happens during a metal reroof
The order of work depends on tear-off or re-cover, but the basics are the same.
Assess the old roof
A full look at the panels, framing and attic shows whether the roof can be re-covered or must come off. It also tells whether the framing needs work first.
Plan the new roof
Tear-off, re-cover or metal over shingles is chosen, along with the new panel system, gauge and finish. The new panels are ordered cut to length.
Remove the old roof
The crew unscrews and lifts off the old metal, stacking it for recycling. Only as much roof is opened as can be covered the same workday.
Fix the purlins
The structure is repaired so new fasteners bite into solid wood. Sound framing is what keeps the new roof fastened.
Panel the roof
The roof is dried in, trimmed and paneled, with new boots and flashing at every penetration. Every edge gets new matching trim.
What is included
Parts of a metal reroof
Tear-off
The worn roof is stripped down to the framing so the structure can be inspected.
Metal panels
The new metal system is fastened to the manufacturer pattern.
Re-cover option
Where suitable, new metal goes over the old roof on sub-framing on larger buildings.
Flashing
Matching flashing at every edge instead of reusing old pieces.
Related service
Metal Roof Panel Replacement Succasunna, NJ
Metal roof panel replacement swaps out individual damaged panels instead of the whole roof. On exposed fastener roofs, the roofer removes the screws on the damaged panel and the overlapping edges of its neighbors, slides it out and sets a new one in sealant. Standing seam panel swaps are possible but slower, since the seams on both sides have to be opened.
For a Succasunna building with one or two bad panels, panel replacement is often the sensible step. Expect a slight color difference between new and old metal. If many panels need swapping, a full replacement may make more sense.
Related service
Metal Roof Over Shingles Succasunna, NJ
A metal roof over shingles skips the tear-off and installs panels over the current shingle layer. Where code permits, the roofer adds underlayment or furring strips over the shingles and fastens the metal through to the deck.
The catch is that the decking stays hidden. A roofer in Succasunna should check the attic for rot and soft spots before recommending it, and the shingles must lie flat enough for the panels. If the deck is questionable or there are already two layers, a tear-off is the better choice.
Local help
Metal Roof Replacement Near Me
Around Succasunna, metal reroofs range from rusted farm buildings to houses getting their first standing seam roof. From Succasunna out to neighboring towns such as Ledgewood, Flanders, Landing and Netcong, older metal roofs tend to need full replacement once the coating is gone, and newer houses are adding metal as their shingle roofs wear out, and the right approach depends on what the old roof is hiding.
Need metal roof replacement around Succasunna? Call (862) 453-8001 for a Succasunna roofer who serves the towns around it too.
What the local climate does to a roof
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Succasunna is busiest after a hard winter and before the next one.
Why call
Why not wait
Less damage
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Local roofers see the same roofs and storm damage across Succasunna and nearby towns.
Clear next steps
Ask your questions before you agree to anything.
Common questions about metal roof replacement
When does a metal roof need replacing instead of repair?
The answer depends on how much of the metal is still sound. Widespread rust-through, failed paint and stripped holes everywhere usually mean new metal. Call (862) 453-8001 to have a roofer check the roof and the structure.
What is a metal roof retrofit?
A metal re-cover puts a new metal roof on top of the old one, attached through new framing to the structure. It is common on larger buildings where tearing off would disrupt use. The structure has to be checked first, since the old roof stays in place and adds weight.
Is it a good idea to put metal over shingles?
Local code decides whether metal can go over existing shingles. It saves tear-off and disposal, but it hides the deck, so the attic should be checked for rot and soft spots first. A roofer can tell you which option fits your house.
What happens to the old metal roofing?
Removed metal panels are generally recycled. Metal can be melted down and reused, so it rarely goes to the landfill. Your roofer can explain how the old metal will be hauled away.
How is a single metal roof panel replaced?
Replacing one panel is a routine job on most ribbed and corrugated roofs. The roofer unscrews the panel and its laps, removes it and fastens a matching one in place. New panels may look brighter than the old ones at first.
More questions? Call (862) 453-8001
Often needed together
Metal Roof Installation
New metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, so the roof handles heat, wind and thermal movement.
Learn moreMetal Roof Repair
Metal roof repairs that stop leaks at the screws, laps and flashing, without replacing panels that are still sound.
Learn moreRoof Replacement
Replacing an aging roof with new underlayment, flashing, vents and roofing, so the house is dry for decades instead of seasons.
Learn moreStanding Seam Metal Roof
Long-lasting standing seam roofs, from snap-lock to mechanically seamed panels, built to let the metal move without leaking.
Learn more
Looking for something else?
See all roofing servicesTalk to a Succasunna roofer about metal roof replacement
Call (862) 453-8001 to talk to a roofer serving Succasunna, NJ.