Coating
Compatible coatings can extend the life of weathered EPDM once all leaks are fixed.
Flat Roofing
Rubber Roof Repair Succasunna, NJ
Most leaking rubber roofs in Succasunna can be repaired, since EPDM patches bond well when the surface is cleaned and primed properly, once the actual leak point is located. One call to (862) 453-8001 reaches a nearby rubber roof repair pro.
Most EPDM leaks come from a short list of problems. Seams lead the list, since older EPDM roofs were often seamed with liquid adhesive that breaks down over time. Punctures and failed flashing at walls, curbs and vents round out the usual causes.
Over time, EPDM slowly shrinks, and that causes its own kind of damage. As the sheet contracts, it pulls on the flashing at walls and edges, lifts the membrane off inside corners and can tear the rubber where it bridges between the roof and the wall. Lasting repairs relieve the stretch and add fresh flashing material.
One mistake makes rubber roof repair much harder. Tar and asphalt products damage EPDM and leave a surface that proper patches cannot stick to. For now, protect the inside, avoid the roof in wet weather and write down when the leak shows up.
Rubber Roof Repair is often paired with rubber roof installation and flat roof repair, depending on the cause.
Dealing with this in Succasunna, NJ right now? Call (862) 453-8001 and describe the problem to a roofer who works in Succasunna.
Call nowThe process
How rubber roof repair works
Here is how a roofer usually handles a rubber roof repair.
Find the leak
The inspection traces the leak from the stain back to seams, flashing and penetrations. Wet insulation under the leak is checked with a moisture meter or a small core.
Surface prep
Weathered EPDM is scrubbed with a membrane cleaner to remove dirt, chalking and oxidation. Incompatible old patches come off before anything new goes on.
Apply primer
Primer goes on in a thin, even coat over the cleaned area. Primer turns old, weathered rubber into a surface that tape can grip.
Apply the patch
The patch is laid over the primed area and rolled so it bonds completely. Corners and penetrations use flexible uncured flashing.
Seam repair
Open seams are cleaned, primed and covered with seam tape or a cover strip along their full length. Edges of every patch and seam get a bead of lap sealant.
Fix shrinkage
Shrunk membrane at walls and curbs is released and reflashed with new rubber. The top of the flashing is fastened and sealed.
What is included
Common EPDM repairs
Shrinkage repair
Shrunk edges get new flashing so the roof can move.
Pipe boots
Damaged collars around penetrations are renewed for a tight seal.
Seam repair
Peeling seams are cleaned, primed and taped along their full length.
Tear repair
Holes and tears are patched with EPDM cover tape with rounded corners.
Related service
EPDM Roof Repair Succasunna, NJ
EPDM roof repair follows a strict sequence: clean, prime, patch, roll and seal. Dirt, moisture or skipped primer are the usual reasons an EPDM patch fails. Lap sealant finishes the edges.
Weather matters for EPDM repairs in Succasunna, since primers and adhesives need dry conditions and mild temperatures to bond. In an emergency, a temporary seal can stop water until conditions allow a proper patch. Temporary seals are not a substitute for a primed patch.
Related service
Rubber Roof Replacement Succasunna, NJ
There comes a point where patching an EPDM roof stops being worth it. Seams failing all over, shrinkage pulling at every wall, a brittle and crazed surface or wet insulation across large areas all point toward a new roof. Testing the insulation helps make the call.
Replacement options include new EPDM or a heat-welded membrane like TPO. If the existing roof is a single layer with dry insulation, a recover may be possible, but wet insulation means a tear-off. For a Succasunna home, an honest assessment saves money in the long run.
Local help
Rubber Roof Repair Near Me
Around Succasunna, rubber roofing is found on additions, carports and flat roofs that have been in place for years. From Succasunna to neighboring communities such as Ledgewood, Flanders, Landing and Netcong, storms and years of sun wear seams and flashing on rubber roofs, so a check after big storms is worth it.
Searching for rubber roof repair near me from Succasunna or Ledgewood, Flanders, Landing and Netcong? Call (862) 453-8001 to talk to a roofer who works in your part of town.
Roofs in this climate
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Succasunna, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why act early
Drier ceilings
Small roof problems caught early usually stay small repairs.
Local knowledge
Local roofers see the same roofs and storm damage across Succasunna and nearby towns.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Rubber Roof Repair questions
Should I coat my EPDM roof?
Coating is an option for a sound EPDM roof. The roof must be repaired first, cleaned and primed with an EPDM-compatible primer before an acrylic or silicone coating goes on. A coating is not a fix for an active leak.
Can I use roofing tar on a rubber roof?
Roofing tar and roof cement are not compatible with EPDM. They attack the membrane and make future repairs much harder. The right fix is a primed EPDM patch.
What is the right way to patch EPDM?
A proper EPDM patch is a cleaned, primed and rolled repair. The roofer scrubs the area with membrane cleaner, applies primer, lets it flash off, then presses down a patch with rounded corners and rolls it firmly. Edges are sealed with lap sealant.
What is the lifespan of an EPDM roof?
EPDM can last 20 years or more, sometimes much longer. Roofs with good drainage and maintained seams last longest. Repairs keep it on track.
Why is my rubber roof pulling away from the wall?
Shrinkage is the usual cause. The shrinking membrane tugs at the perimeter and bridges across corners. The fix is relieving the tension and adding new flashing.
More questions? Call (862) 453-8001
Often needed together
Rubber Roof Installation
New EPDM rubber roofs laid in wide sheets over insulation and a cover board, with primed and taped seams, so the roof stays flexible and watertight for decades.
Learn moreFlat Roof Repair
Repairs for leaking flat roofs, from punctures and seams to clogged drains and wet insulation, so the roof sheds water again without a full replacement.
Learn moreRoof Coating
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, when the roof underneath is still dry and solid.
Learn moreRoof Leak Repair
Stopping water at the pipe boots, flashing, valleys and nail holes where roofs actually leak, with the damage underneath checked too.
Learn more
Looking for something else?
See all roofing servicesTalk to a Succasunna roofer about rubber roof repair
Call (862) 453-8001 to talk to a roofer serving Succasunna, NJ.